ここから本文です
TWO:That the book was not published sooner is because I could not foresee more than others how terribly long the war would last; and I should have preferred to wait till the end in order to insert several reports which I know are being kept in the occupied part, in order to acquaint the whole world with the full truth about the behaviour of the Germans. As long as the Germans keep the upper hand in Belgium, such a publication cannot take place without danger to several persons."Oh yes! You may have that!"
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:"Not I!" she said. "I've got all my season's losings back, and I've done with this kind of thing, right here. I'm very fond of Longmere in my funny way, and I'm not going to deceive him any more. But I shall be afraid to go home with all these notes on me.""It's about that business of Dr. Gordon Bruce," Isidore said curtly. "Now, my friend Wolffman, you know me and I know you. I don't want to ruin you body and bones, but I shall do so unless you listen to reason. You are going to write to Dr. Bruce, and tell him the matter shall stand over for the present----"

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:Of course, there was always the chance of coming on the track obliquely. None knew better than Prout how frequently one crime interlocked with another, and how often in looking for one particular criminal another had been arrested.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:Argenteau was not damaged much, but the inhabitants remained quietly inside their houses, or probably stayed in their cellars, for fear of the shells that tore through the air constantly.A drawing being inked in, the next things are tints, dimension, and centre lines. The centre lines should be in red ink, and pass through all points of the drawing that have an axial centre, or where the work is similar and balanced on each side of the line. This rule is a little obscure, but will be best understood if studied in connection with a drawing, and perhaps as well [84] remembered without further explanation.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.